Lucent Technologies Release 8.2 manual Setting Up Centralized Voice Mail Via Mode Code

Centralized Voice Mail Via Mode Code B Private Networking

Setting Up Centralized Voice Mail Via Mode Code

The following step describe how to set up DEFINITY switches to support centralized voice mail. For information on setting up Merlin Legend/Merlin Magix, see Merlin Magix Integrated Systems Network Reference, 555-715-114. For information on setting up INTUITY Messaging Solutions, see INTUITY Messaging Solutions Integration with System 75, Generic 1 and 3, and R5/6.

Begin

1Enter change system-parameterscustomer-optionson the command line of your system administration screen.

2On page 3, verify fields as follows:

~ISDN-PRI field is y.

~Mode Code for Centralized Voice Mail? field is y.

~Mode Code Interface? field is y.

~UDP field is y.

3On the hub switch, enter add trunk group xxxx on the command line of your system administration screen, where xxxx is the number of the ISDN-PRI trunk group connecting the hub with the remote switch.

4On page 1, verify fields as follows:

~Group Type field is ISDN.

~Service Type field is TIE.

5On page 2, verify fields as follows:

~Send Name field is y.

~Send Calling Number field is y.

~Numbering Format field is Private.

~Send Connected Number field is y.

6On each remote switch, repeat steps 3-5.

7On each DEFINITY switch in the network, enter change dialplan on the command line of your system administration screen.

8Administer the dial plan for each node in the network (see Chapter 4 in this document for examples). Usually the hub is considered Node 1.

If the network contains Merlin Legend/Magix systems:

~Uniform Dialing Plan field is 4 for each node.

If the network contains only DEFINITY systems:

~Uniform Dialing Plan field is 4 or 5.

9For each DEFINITY node, enter change feature-access-codeson the command line.

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	397