Lucent Technologies Release 8.2 manual Add data next

Configuration 2: R7r (+CMS) <—ethernet—> R7csi 3 C-LAN Administration

Switch 2 Task— Assign Link via ethernet Data Module to the LAN

This task administers an ethernet data module on Switch 2 for the ethernet connection to Switch 1. The data module associates a link number with a port address, extension number, and node name for the C-LAN port used for this connection.

Steps

Begin

> Open Data Module form — enter ad da n

add data next

Page 1 of X

		DATA MODULE
Data Extension:	3201	Name: ethernet on link 5
Type:	ethernet
Port:	01a0517_
Link:	5

Network uses 1’s for broadcast addresses? y

[This data module is assigned the next available extension, 3020.]

> Enter values

Field	Conditions/Comments
Type:	This indicates the data-module type for this link.
Port:	Ethernet connections must be assigned to port 17 on the C-LAN
	circuit pack. In this example, the C-LAN circuit pack is in slot
	1a05.
Link:	The link number must be in the range 1 – 25 (R8csi), not
	previously assigned on this switch.
Name:	Information-only; appears in list generated by the “list data
	module” command.
Network uses	Leave the default (y) if the private network contains only
1’s for	DEFINITY switches and adjuncts. Set to n only if the network
broadcast	includes non-DEFINITY switches that use the 0’s method of
addresses?	forming broadcast addresses. See Appendix A, “Data Module -
	type ethernet” for more information about this field.
> Submit the screen
End

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	87