Lucent Technologies Release 8.2 manual Switch 1 Task Assign Link via ppp Data Module to Switch

Configuration 1: R8r <—ppp—> R8si 3 C-LAN Administration

Switch 1 Task — Assign Link via ppp Data Module to Switch 2

This task administers a ppp data module on Switch 1 for the ppp connection to Switch

2.The data module defines a network interface — it associates a link number with a port address and node name for the C-LAN port on Switch 1. It also specifies the node name for the destination node, which is a C-LAN port on Switch 2.

Steps

Begin

> Open Data Module form — enter ad da n

add data-module next

			Page 1 of x
	DATA MODULE
Data Extension:	2010		Name: _ppp on link 1 to node-2___ BCC: 2
Type:	ppp		COS: 1
Port:	01b0115		COR: 1
Link:	1_		TN: 1
Enable Link?	n
Node Name:	node-1	_____
Subnet Mask:	255.255.255.0
Establish Connection: y
DESTINATION
Digits:	6113020________
Node Name:	node-2_________
CHAP?	n

[The system assigns the extension 2010 to this data module. Instead of n (next) in the command line, you could specify any unused extension in the dial plan.]

> Enter values

	Field	Conditions/Comments
	Type:	This indicates the data-module type for this connection (ppp).
	Port:	In this example, the C-LAN circuit pack is in slot 01b01; the ppp
		connection is through port 15.
	Link:	For G3r, the link number must be in the range 1 – 33, not
		previously assigned on this switch.
	Enable Link?	If you need to add an IP route that uses this node as a gateway,
		this field must be set to y before adding the IP route. Otherwise
		leave this field set to n until the link administration is complete;
		that is, until after all data modules and the processor channels are
		assigned, then set to y.
	Name:	Information-only; appears in list generated by the "list data
		module" command.
		1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000		CID: 77730	63