Lucent Technologies Release 8.2 manual Cos, Dte/Dce

Configuration 3: R8si<—x.25 —> R8r Gateway			3 C-LAN Administration
<—ethernet—> R8si
	Field	Conditions/Comments
	Name:	Information-only; appears in list generated by the “list data
		module” command.
	COS:
		The values for these fields will be specified by the system
	COR:
		administrator.
	TN:
	DTE/DCE:	The DTE/DCE assignments must be opposites on the two ends
		of the connection. Use dce for node 2.
	Enable Link?	Set to y after the processor channels have been assigned.
	Remote	Set to n unless testing.
	Loop-Around
	Test?
	Destination	external is used when connecting an r-model to an si-model.
	Number:	For an r-to-r connection, enter the TAC+extension.
	Establish	y means that this switch will be responsible for the call setup
	Connection?	for this connection. Enter n when administering the data
		module for Switch 2.
	Connected	Extension of node-2 data module.
	Data Module
	Error Logging?	Set to n for normal operations.
		Set to y for testing — logs all data module errors.
	Permanent	Always y for DCS, CMS, and Intuity AUDIX.
	Virtual Circuit?
	Switched	Always n for DCS, CMS, and Intuity AUDIX.
	Virtual Circuit?
	Highest PVC	Set to 64 (the default) for normal operations.
	Logical
	Channel:
			2 of 2
	> Submit the screen
	End

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	105