Lucent Technologies Release 8.2 manual Switch 2 Task Assign Processor Channels

Configuration 3: R8si<—x.25 —> R8r Gateway	3 C-LAN Administration
<—ethernet—> R8si

Switch 2 Task — Assign Processor Channels

This task associates data links (hardware) with processor channels (software) on

Switch 2.

Steps

		Begin
		> Open Processor Channel Assignment form — enter						ch com p
change communications-interface processor-channels
									Page 1 of X
				PROCESSOR CHANNEL ASSIGNMENT
Proc		Gtwy		Interface		Destination		Session		Mach
Chan Enable		Appl. To	Mode	Link/Chan		Node	Port	Local/Remote		ID
1:	n	_______	_	__	_____	_________	0____	___	___	__
2:	n	_______	_	__	_____	_________	0____	___	___	__
:
21:	y	dcs____	_	2_	21___	_________	0____	21_	21_	1_
23:	y	dcs____	_	2_	23___	_________	0_ _	23_	23_	3_
	:
256:	n	_______	_	__	_____	_________	0____	___	___	__

Note: The Processor Channel number, the Interface Channel number, and the Local and Remote Session numbers do not need to be the same number but they should be made the same whenever possible to simplify network “bookkeeping” and diagnostics.

> Enter values

Field

Conditions/Comments

Processor Channel 21: (X.25 connection to Switch 1)

Enable	Set to y.
Appl.	Set to dcs for DCS signaling.
Mode	Used for TCP/IP connections only.
Interface Link	This must match the link number assigned on the procr-intf
	data module screen.
Interface Chan	The interface channel number must be in the range 1 – 64
	for an X.25 link.
Destination Node	Used for TCP/IP connections only.
Destination Port	Used for TCP/IP connections only.
	1 of 2

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	115