Configuration 5A: R8csi <—ppp—> R8r (one C-LAN)

3 C-LAN Administration

<—ethernet—> R8si

 

Switch 2 Task — Assign IP Route to node-3

This task specifies an initial route for messages handled by node-2 that are destined for node-3. An IP route is required for this route because there are intermediate nodes between node-2 and node-3.

Steps

Begin

> Enable the ppp link on the node-2 data module screen:

ch da 3020, set Enable Link? to y.

>Open the IP Routing form — enter a ip n

add ip-route next

 

Page 1 of 1

 

IP ROUTING

Route Number:

1

 

Destination Node:

node-3____

Gateway:

node-1-ppp

 

C-LAN Board:

1a04

Metric:

0

 

 

 

 

[The system assigns the route number 1.] > Enter values

Field

Conditions/Comments

 

 

Destination Node:

The name of the node at the destination of this route.

 

 

Gateway:

Node name of the gateway by which the destination node is

 

reached for this route.

 

 

C-LAN Board:

The location of the C-LAN circuit pack that provides the

 

interface for this route.

 

 

Metric:

Enter 0.

 

See IP Routing (page 251) in Appendix A for more

 

information on the use of the Metric field.

 

 

> Submit the screen

 

End

Administration for Network Connectivity

 

 

555-233-504 — Issue 1 — April 2000

CID: 77730

163

Page 183
Image 183
Lucent Technologies Release 8.2 Switch 2 Task Assign IP Route to node-3, See IP Routing page 251 in Appendix a for more