H.323 Trunk Administration

 

 

 

2 H.323 Trunks

 

 

 

 

 

 

 

 

 

 

 

Field

 

Conditions/Comments

 

 

 

 

 

 

 

 

 

 

 

Far-end Node Name:

This is the node name for the far-end C-LAN IP

 

 

 

 

 

 

Interface used for trunks assigned to this signaling

 

 

 

 

 

group. The node name must be administered on the

 

 

 

 

 

Node Names form on this switch.

 

 

 

 

 

 

 

 

This field can be left blank if the signaling group is

 

 

 

 

 

associated with an unspecified destination.

 

 

 

 

 

 

 

 

 

 

Far-end Listen Port:

The same number as entered in the Near-end Listen

 

 

 

 

 

 

Port field is recommended; this number must match the

 

 

 

 

 

number entered in the Near-end Listen Port field on the

 

 

 

 

 

signaling group form for the far-end switch.

 

 

 

 

 

 

 

This field can be left blank if the signaling group is

 

 

 

 

 

associated with an unspecified destination.

 

 

 

 

 

 

 

 

 

 

 

 

 

LRQ Required?

 

Leave the default (n) if the far-end switch is a

 

 

 

 

 

 

 

DEFINITY ECS. Set to y only if the far-end switch is a

 

 

 

 

 

non-DEFINITY switch and requires a location request

 

 

 

 

 

(to obtain a signaling address) in its signaling protocol.

 

 

 

 

 

 

 

 

 

Calls Share IP

 

Always enter y for inter-DEFINITY connections. If the

 

 

 

 

Signaling Connection?

local and/or remote switch is a non-DEFINITY switch,

 

 

 

 

 

leave the default (n).

 

 

 

 

 

 

 

 

 

 

 

 

Bypass if IP Threshold

Set to y to automatically remove from service trunks

 

 

 

 

Exceeded?

 

assigned to this signaling group when IP transport

 

 

 

 

 

performance falls below limits administered on the

 

 

 

 

 

Maintenance-Related System Parameters (sys par

 

 

 

 

 

maint) screen.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2 of 2

 

 

 

 

 

 

 

 

 

 

 

 

 

>Go to page 2

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

add signaling-group next

 

 

Page

2 of

5

 

 

 

 

ADMINISTERED NCA TSC ASSIGNMENT

 

 

 

 

Service/Feature:

As-needed Inactivity Time-out (min):

 

 

 

TSC

Local

 

 

 

Mach.

 

 

 

Index

Ext. Enabled Established

Dest. Digits Appl.

 

ID

 

 

 

1:

n

 

 

 

 

 

 

 

2:

n

 

 

 

 

 

 

 

3:

n

 

 

 

 

 

 

 

4:

n

 

 

 

 

 

 

 

5:

n

 

 

 

 

 

 

 

6:

n

 

 

 

 

 

 

 

7:

n

 

 

 

 

 

 

 

8:

n

 

 

 

 

 

 

 

 

 

 

 

 

 

If this signaling group will be used for DCS, enter NCA TSC information here. See

 

 

Chapter 3, Configuration 4, for instructions.

 

 

 

 

 

 

 

> Submit the screen

 

 

 

 

 

 

 

 

 

End

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Administration for Network Connectivity

44

 

 

 

CID: 77730

555-233-504 — Issue 1 — April 2000

Page 64
Image 64
Lucent Technologies Release 8.2 manual Configuration 4, for instructions Submit the screen