Lucent Technologies Release 8.2 This form applies only to the r model, Baud Rate, Endpoint Type

Networking Screens							A Screens Reference
Data Module - type X.25 (used for BX.25 connections with the r model)
		This form applies only to the r model.
							Page 1 of 2
				DATA MODULE
Data Extension: ____				Name: ____________________
	Type: x.25						Remote Loop-Around Test? n
	Port: __				COR: 1		Destination Number: ______
Baud Rate: __________					TN: 1		Establish Connection? n
Endpoint Type:_________							Connected Data Module: ____
	Link: 1_		DTE/DCE: ___				Error Logging? _
			Enable Link? n
Permanent Virtual Circuit? _						Highest PVC Logical Channel: __
Switched Virtual Circuit? _
Common Fields		See Common Data Module Fields (256) for descriptions of fields on this screen that
		are not listed below.
Baud Rate		Specifies the data transmission rate for this connection.
			Valid entries			Usage
			9600, 19200, switched			Set to 9600 for DCS connections to the si model, or to
						an r model with an external 9600 baud data line.
						Set to switched for r-to-r connections with
						common-channel signaling on DS1 trunks.
						Set to 9600 for connections to Intuity.
						Set to either 9600 or 19200 for CMS, depending on
						the physical connectivity.
Endpoint Type		Must be assigned as adjunct. An endpoint type is a type of packet switched data
		endpoint that uses X.25 call control procedures. The X.25 Endpoint connects to
		external ports on the PGATE board and to the TDM bus via a DS1 trunk. Ports
		connected to the adjunct endpoint can be either DTEs or DCEs.
			Valid entries		Usage
			adjunct		Set to adjunct for DCS, CMS, or Intuity AUDIX.

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	269