Lucent Technologies Release 8.2 manual Name IP Address Default Node-1-ppp 192 Node-2 Node-3 192

Configuration 5A: R8csi <—ppp—> R8r (one C-LAN)	3 C-LAN Administration
<—ethernet—> R8si

Switch 2 Task — Assign Node Names

This task assigns node names and IP addresses to each node in the network. This screen is administered on Switch 2. A Node Names screen must be administered on each switch in the network.

The node names and IP addresses in any network should be assigned in a logical and consistent manner from the point of view of the whole network. These names and addresses should be assigned in the planning stages of the network and should be available from the customer system administrator or from a Lucent representative.

Note: Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter node names for switches, routers, and CMS starting on page 2.

Steps

Begin

> Open Node Names form — enter ch node-n> Go to page 2

change node-names

				Page 2 of 6
		NODE NAMES
Name		IP Address	Name	IP Address
default_________	0__.0__.0__.0__		_______________	___.___.___.___
node-1-ppp	192.168.10_.130		_______________	___.___.___.___
node-2 ___	192.168.10_.12_		_______________	___.___.___.___
node-3__________ 192.168.10_.129			_______________	___.___.___.___
________________ ___.___.___.___			_______________	___.___.___.___
		> Enter values.
		Field	Conditions/Comments
		Name	Enter unique node names for the following 3 nodes:
			• C-LAN PPP port on Switch 2
			• C-LAN PPP port on Switch 1.
			• C-LAN Ethernet port on Switch 3
		IP Address	The unique IP addresses of the nodes named in the previous
			field.
		> Submit the screen
		End

		Administration for Network Connectivity
158	CID: 77730	555-233-504 — Issue 1 — April 2000