Lucent Technologies Release 8.2 manual Issue 1 April CID 185

Configuration 5B: R8csi <—ppp—> R8r (2 C-LANs)			3 C-LAN Administration
<—ethernet—> R8si
	Field	Conditions/Comments
	Destination Node	Name of the far-end node for this channel. This must be a
		name entered on the Node Names screen. For ppp
		connections, it must match the Destination Node Name
		entered on the ppp Data Module screen.
	Destination Port	A value of 0 allows any available interface channel on the
		destination node to be used for this connection. The Interface
		Channel number on the Switch-2 Processor Channel screen
		must also be set to 0.
	Session - Local	The Local and Remote Session numbers can be any value
		between 1 and 256 (si model) or 384 (r model), but they must
	Session - Remote
		be consistent between endpoints. For each connection, the
		Local Session number on this switch must equal the Remote
		Session number on the remote switch and vice versa.
		It is allowed, and sometimes convenient, to use the same
		number for the Local and Remote Session numbers. It is
		allowed, but not recommended, to use the same Session
		numbers for two or more connections.
	Mach ID	Destination switch ID identified on the dial plan of the
		destination switch.

Processor Channel 13: (ethernet connection to Switch 3)

	Enable	Set to y.
	Appl.	Set to dcs for DCS signaling.
	Mode	Node-1d is the “server” for this session. Set to node-3 to
		“client” ( c).
	Interface Link	This must match the link number assigned on the node -1d
		data module screen.
	Interface Chan	or TCP/IP, interface channel numbers are in the range 5000 –
		64500.
		The recommended values are: 5001 for CMS, 5002 for Intuity
		AUDIX, and 5003 for DCS connections that are not
		gateways. These three values should be reused for multiple
		instances of these applications. The combination of Link,
		Interface Channel, and Mach ID must be unique.
		This number must match the Destination Port number on the
		Switch-3 Processor Channel screen
	Destination Node	Name of the far-end node for this channel. This must be a
		name entered on the Node Names screen.
	Destination Port	A value of 0 allows any available interface channel on the
		destination node to be used for this connection. The Interface
		Channel number on the Switch-3 Processor Channel screen
		must also be set to 0.
		2 of 3
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000		CID: 77730	185