Lucent Technologies Release 8.2 manual 424 CID

IP Trunk Administration					F IP Trunk Installation and
								Administration
				TRUNK GROUP
				Administered Members(min/max):				1/12
				Total Administered Members: 12
	GROUP MEMBER ASSIGNMENTS
	Port	Code	Sfx Name	Night Mode	Type		Ans Delay
	1: 01A0901	___________		___________	_____	________		_______ ____
	2: 01A0902	___________		___________	_____	________		_______ ____
	3: 01A0903	___________		___________	_____	________		_______ ____
	4: 01A0904	___________		___________	_____	________		_______ ____
	5: 01A0905	___________		___________	_____	________		_______ ____
	6: 01A0906	___________		___________	_____	________		_______ ____
	7: 01A0907	___________		___________	_____	________		_______ ____
	8: 01A0908	___________		___________	_____	________		_______ ____
	9: 01A0909	___________		___________	_____	________		_______ ____
	10: 01A0910	___________		___________	_____	________		_______ ____
	11: 01A0911	___________		___________	_____	________		_______ ____
	12: 01A0912	___________		___________	_____	________		_______ ____
	13: _______	___________		___________	_____	________		_______ ____
	14: _______	___________		___________	_____	________		_______ ____
	15: _______	___________		___________	_____	________		_______ ____

6Press ENTER to save your changes.

Administer AAR/ARS You can use Automatic Alternate Routing (AAR) and Automatic Route Selection (ARS) to route calls over an IP trunk group just like any other trunk group. Unlike other trunk groups, however, you must administer both the DEFINITY ECS switch software and Configuration Manager to route calls over IP trunks. DEFINITY ECS uses the dialed digit string to select a route pattern — and thus a trunk group — for each call. The IP Trunk software matches each trunk line or each dialed string to a specific IP address.

The following administration needs to be performed on both the origin and destination switches — if you can’t administer the remote switch, coordinate this work with the administrator at the other site. The following general instructions assume that you know how to use Automatic Alternate Routing (AAR) and Automatic Route Selection (ARS) to route conventional calls.

To administer IP call routing on DEFINITY ECS:

1Administer the AAR and ARS Digit Analysis Table on DEFINITY ECS with the information you entered in the Switch Admin tables on the worksheet.

2After you’ve assigned a route pattern in the AAR or ARS Digit Analysis Table, add the IP trunk group to that route pattern if you haven’t already done so

3Make the IP trunk group the first preference in the route pattern and perform any other administration required on the Route Pattern screen.

Note: If you want to route calls over the normal telephone network when transmission quality over the IP network is unacceptable, assign one or more conventional trunk groups to the route pattern as backups.

DEFINITY ECS will route appropriate calls to the IP trunk group. Now you need to administer Configuration Manager to route outgoing and incoming calls appropriately.

		Administration for Network Connectivity
424	CID: 77730	555-233-504 — Issue 1 — April 2000