Lucent Technologies Release 8.2 Switch 1 Task Assign Link via ppp Data Module to C-LANa, Bcc

Configuration 5B: R8csi <—ppp—> R8r (2 C-LANs)	3 C-LAN Administration
<—ethernet—> R8si

Switch 1 Task — Assign Link via ppp Data Module to C-LAN(a)

This task administers a ppp data module on Switch 1 for the ppp connection from the

C-LAN(b) circuit pack to the C-LAN(a) circuit pack.

Steps

Begin

> Open Data Module form — enter ad da 2378

add data-module 2378

				Page 1 of x
				DATA MODULE
Data Extension: 2378				Name: _ppp on link 21 to clan(a)_ BCC: 2
Type: ppp				COS: 1
Port: 01c0815				COR: 1
Link: 21				TN: 1
Enable Link? n
Node Name: node-1b_____
Subnet Mask: 255.255.255.0
Establish Connection: n
DESTINATION
Digits:		______
Node Name: node-1a______
CHAP? n
> Enter values
	Field		Conditions/Comments
	Type:		This indicates the data-module type for this link.
	Port:		In this example, the C-LAN(b) circuit pack is in slot 01c08; the
			ppp connection is through port 15.
	Link:		The link number must be in the range 1 – 33 (for R8r), not
			previously assigned on this switch
	Enable Link?		If you need to add an IP route that uses this node as a gateway,
			this field must be set to y before adding the IP route. Otherwise
			leave this field set to n until the link administration is complete;
			that is, until after all data modules and the processor channels are
			assigned, then set to y.
	Name:		Information-only; appears in list generated by the “list data
			module” command.
	BCC:		Bearer Capability Class. This is a display-only field.
				1 of 2

		Administration for Network Connectivity
180	CID: 77730	555-233-504 — Issue 1 — April 2000