Lucent Technologies Release 8.2 manual 420 CID

IP Trunk Administration	F IP Trunk Installation and
	Administration

For any two-site configuration, you would fill out Worksheet 1 and one of the worksheets 2–8. Use the worksheets as follows:

1Fill out the general information about your sites using Worksheet 1.

The Field Codes on Worksheet 1 consist of a number (1 or 2) that indicates the site, and a letter (A–J) that indicates a field on an administration screen. For each code, the Field Value column holds the specific value for that field for your switches. The field codes are used on all the other worksheets to indicate the values to enter from Worksheet 1.

For example, field code 1A corresponds to the field International Access code for site 1. You would enter the value in the Field Value column for the International Access code for your site-1 switch. Then, when 1A appears on a subsequent worksheet, you would enter the value corresponding to 1A from Worksheet 1.

2Use the second and subsequent worksheets to plan switch and IP Trunk administration.

On each worksheet, in the Fill in with your actual values column, replace the indicated field codes with the corresponding values you entered on Worksheet 1.

For example, on Worksheet 2 there is a field called Different Country for each site. Its field code is 1A2B2D2E, which means that you would enter the values from Worksheet 1 as follows:

<Site-1 International Access Code><Site-2 Country Code><Site-2 Area Code><Site-2 Exchange>

Once you’ve done this, the result is the exact phone number that you’ll enter in the matching field in the administration software.

Note: The IP Trunk application only recognizes digits. Don’t use characters such as ~w, ~p, + and so on in dialed digit formats that will be sent to IP trunks: the application won’t recognize these characters.

3Use these worksheets to administer all your sites using IP Trunk. You can permit a different level of off-premise dialing for each site. For example, Site 1 may allow limited off-premise dialing, but Site 2 may not, and so on.

		Administration for Network Connectivity
420	CID: 77730	555-233-504 — Issue 1 — April 2000