Lucent Technologies Release 8.2 manual Trunk Group

IP Trunk Administration				F IP Trunk Installation and
						Administration
			TRUNK GROUP
	Group Number: 5__		Group Type: tie		CDR Reports: y
	Group Name: IP Trunk 01A09			COR: 85_	TN: 1__	TAC: 105_
	Direction: two-way_	Outgoing Display? y			Trunk Signaling Type: ____
	Dial Access? n	Busy Threshold: 99_			Night Service: ____
	Queue Length: 0__				Incoming Destination: ____
	Comm Type: voice			Auth Code? n
	TRUNK PARAMETERS
	Trunk Type (in/out): wink/wink___			Incoming Rotary Timeout(sec): 5_
	Outgoing Dial Type: tone_____			Incoming Dial Type: tone____
	Wink Timer (msec): 300			Disconnect Timing(msec): 500_
	Digit Treatment: insertion					Digits: 9___
					Sig Bit Inversion: none
	Connected to Toll? n	STT Loss: low			DTT to DCO Loss: normal
	Incoming Dial Tone? y
	Disconnect Supervision - In? y		Out? n
	Answer Supervision Timeout: 0__			Receive Answer Supervision? y

Note: Depending on how the routing between sites is administered, inserting digits may be required. The example shows a "9" being inserted in front of any digits received from the IP Trunk. In most DEFINITY ECS switches, this is the access code for ARS and will allow the digits received on the trunk to be analyzed and rerouted based on ARS analysis table entries.

2Enter the field values as shown in the screen diagram above.

Note: All IP trunk groups are administered as DS1 tie trunks (Group Type = tie).

3Move to the Trunk Features page and type n in the Maintenance Tests field.

4In the Suppress # Outpulsing field, type y.

Note: You may need to fill in other fields for your system.

5Move to the Group Member Assignments page and add the ports (channels) you’ve purchased.

You’re assigning virtual ports, or channels, to the IP Trunk circuit pack. Each channel can carry one call at a time. The number of ports you can use is limited to the maximum number specified in your license.

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	423