Lucent Technologies Release 8.2 manual Extension in the dial plan Enter values

Configuration 4: R8csi <—ISDN—> R8si Gateway	3 C-LAN Administration
<—ppp—> R8csi

Switch 1 Task — Assign Link via ppp Data Module to Switch 3

This task administers a ppp data module for the ppp connection to node 3. The data module associates a link number with a port address, extension number, and node name for the C-LAN port used for this connection.

Steps

Begin

> Open Data Module form — enter ad da 5803

add data-module 5803

Page 1 of x

	DATA MODULE
Data Extension: 5803				Name: _ppp on link 1 to node-3___	BCC: 2
Type: ppp				COS: 1
Port: 01b1115				COR: 1
Link: 1_				TN: 1
Enable Link? n
Node Name: node-1		_____
Subnet Mask: 255.255.255.0
Establish Connection: y
DESTINATION
Digits: 792801_________
Node Name: node-3_________
CHAP? n
[This data module is assigned the extension 5803; you can assign any unused
extension in the dial plan]
> Enter values
	Field		Conditions/Comments
	Type:		This indicates the data-module type for this connection.
	Port:		In this example, the C-LAN circuit pack is in slot 01b11; the ppp
			connection is through port 15.
	Link:		The link number must be in the range 1 – 25 (for R8si), not
			previously assigned on this switch.
	Enable		If you need to add an IP route that uses this node as a gateway,
	Link?		this field must be set to y before adding the IP route. Otherwise
			leave this field set to n until the link administration is complete;
			that is, until after all data modules and the processor channels are
			assigned, then set to y.
	Name:		Information-only; appears in list generated by the “list data
			module” command.
					1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000				CID: 77730	127