Lucent Technologies Release 8.2 For each connection, the Local Session number on this switch

Configuration 3: R8si<—x.25 —> R8r Gateway			3 C-LAN Administration
<—ethernet—> R8si
	Field	Conditions/Comments
	Session - Local	The Local and Remote Session numbers can be any value
		between 1 and 256 (si model) or 384 (r model), but they must
	Session - Remote
		be consistent between endpoints. For each connection, the
		Local Session number on this switch must equal the Remote
		Session number on the remote switch and vice versa.
		It is allowed, and sometimes convenient, to use the same
		number for the Local and Remote Session numbers. It is
		allowed, but not recommended, to use the same Session
		numbers for two or more connections.
	Mach ID	Destination switch ID identified on the dial plan of the
		destination switch.

Processor Channel 23: (The X.25 side of the gateway)

Enable	Set to y.
Appl.	Use gtwy-tcpfor conversion between X.25 and TCP/IP.
Gateway To	Indicates a software connection between processor channels
	23 and 32.
Mode	Used for TCP/IP connections only.
Interface Link	This must match the link number assigned on the x.25 data
	module screen.
Interface Chan	The interface channel number must be in the range 1 – 64 for
	an X.25 link.
Destination Node	Used for TCP/IP connections only.
Destination Port	Used for TCP/IP connections only.
Session - Local	For each connection, the Local Session number on this switch
	must equal the Remote Session number on the remote switch
Session - Remote
	and vice versa.
Mach ID	Leave blank for gtwy-tcp.
Processor Channel 31: (ethernet connection to Switch 3)
Enable	Set to y.
Appl.	Set to dcs for DCS signaling.
Mode	Node-1 is the “server” for this session. Set node-3 to “client”
	(c).
Interface Link	This must match the link number assigned on the node-1 data
	module screen.
	2 of 4

		Administration for Network Connectivity
110	CID: 77730	555-233-504 — Issue 1 — April 2000