Lucent Technologies Release 8.2 manual Open Data Module form enter a da n

Configuration 2: R7r (+CMS) <—ethernet—> R7csi 3 C-LAN Administration

Switch 1 Task — Assign Link via ethernet Data Module to the LAN

This task administers an ethernet data module for the ethernet connection to the CMS adjunct and to Switch 2. The data module defines a network interface — it associates a link number with a port address and node name for the C-LAN port used for this connection.

Steps

Begin

> Open Data Module form — enter a da n

add data-module next

Page 1 of X

		DATA MODULE
Data Extension: 2377		Name: ethernet on link 2
Type: ethernet
Port: 01c0817_
Link: 2
Network uses 1’s for broadcast addresses? y
	> Enter values
	Field	Conditions/Comments
	Type:	This indicates the data-module type for this link.
	Port:	Ethernet connections must be assigned to port 17 on the C-LAN
		circuit pack.
	Link:	The link number must be in the range 1 – 33 (for G3r), not
		previously assigned on this switch.
	Name:	This field is information-only; it appears in lists generated by the
		“list data module” command.
	Network	Leave the default (y) if the private network contains only
	uses 1’s for	DEFINITY switches and adjuncts. Set to n only if the network
	broadcast	includes non-DEFINITY switches that use the 0’s method of
	addresses?	forming broadcast addresses. See Appendix A, “Data Module -
		type ethernet” for more information about this field.

> Submit the screen

End

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	79