Lucent Technologies Release 8.2 manual IP Trunk Installation, Title Document Issue Number

F IP Trunk Installation and

Administration

ky yy k ——
keG8A _g _y——	keG8AR _g _— _g k
y	— eG8AR _g _y—	mode for H.323 trunks — this

material is covered in Chapter 2.

DEFINITY ECS with Internet Protocol (IP) Trunk allows you to route voice and fax calls over IP networks to other DEFINITY ECSs that also have this feature, or to other PBXs (Lucent or non-Lucent) equipped with the Internet Telephony Server–Enterprise (ITS-E). The IP Trunk service enables you to reduce long-distance charges and gives you added flexibility in routing traffic between sites. IP Trunk is implemented using the TN802 circuit pack.

IP Trunk connections can be used with Release 7 and Release 8 of all three

DEFINITY ECS switch models — csi, si, and r.

To use the IP Trunk feature, the IP Interface assembly needs to be installed. The IP Interface assembly (J58890MA-1 L30) is a 3-slot wide TN802 (R7) or TN802B (R8) MAPD circuit pack.

The procedures in this appendix apply to the following software/circuit pack configurations:

•R8 with the IP Interface/TN802B in IP Trunk mode

•R8 configured as R7 (bugfix) with the IP Interface/TN802 or TN802B in IP Trunk mode

•R7 with the IP Interface/TN802

IP Trunk Installation

For IP Trunk installation procedures, see the upgrades or installation document that is appropriate for the switch model. There are five upgrades/installation documents on the DEFINITY Documentation Library CD-ROM. See DEFINITY ECS R8.2 Documentation CD-ROM, 555-233-813.

	Title		Document	Issue
			Number	Number
	Upgrades and Additions for R8.2r		555-233-115	1
	Upgrades and Additions for R8.2si		555-233-122	1
	Installation and Test for Multicarrier Cabinets		555-233-114	1
	Installation and Test for Single Carrier Cabinets		555-233-120	1
	Installation, Upgrades, and Additions for CMC		555-233-118	1
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000		CID: 77730		417