Lucent Technologies Release 8.2 manual Switch 2 Task Assign IP Route to Switch, Ip n

Configuration 2: R7r (+CMS) <—ethernet—> R7csi 3 C-LAN Administration

Switch 2 Task — Assign IP Route (to Switch 1)

This task specifies a route for packets sent by the node 5 IP interface (the ethernet port on the switch-2 C-LAN board) to the nodes 1 and 2. An IP route is required because node 5 is on a different subnetwork from nodes 1&2 (as defined in the Subnet Mask field on the IP Interfaces screen), and the Gateway Address field for node 5 on the IP Interfaces screen was left blank.

The Destination Node will be set to “net-96”, which is associated with the network IP address of 192.168.1.96 on the Node Names screen. This will enable node 5 to communicate with any node on the 192.168.1.96 subnetwork.

Steps

Begin
> Open the IP Routing form — enter				a ip n
	add ip-route next				Page 1 of	1
				IP ROUTING
	Route Number: 2
	Destination Node: net-96			___
		Gateway: node-4
	C-LAN Board: 1c05
		Metric: 0
[The system assigns the route number 2.]
> Enter values
	Field		Conditions/Comments
	Destination		The name of the node at the destination of this route. In this case,
	Node:		net-96 is associated with IP address 192.168.1.96 on the Node
			Names screen. This is the network IP address of the subnet that
			nodes 1 and 2 are on. See the description of the Subnet Mask field
			in Switch 1 Task — Assign IP Interfaces (page 77) .
	Gateway:		Node name of the IP-route gateway by which the destination node
			is reached for this route. In this case, it is the node name of the
			router port.
	C-LAN		The location of the C-LAN circuit pack that provides the interface
	Board:		for this route.
	Metric:		Enter 0.
			See IP Routing (page 251) in Appendix A for more information
			on the use of the Metric field.

> Submit the screen

End

		Administration for Network Connectivity
88	CID: 77730	555-233-504 — Issue 1 — April 2000