Lucent Technologies Release 8.2 manual Switch 3 Task Assign Processor Channels

Configuration 3: R8si<—x.25 —> R8r Gateway	3 C-LAN Administration
<—ethernet—> R8si

Switch 3 Task — Assign Processor Channels

This task associates data links (hardware) with processor channels (software) on

Switch 3.

Steps

Begin

> Open Processor Channel Assignment form — enter ch com p

change	communications-interface processor-channels
								Page 1 of X
				PROCESSOR CHANNEL ASSIGNMENT
Proc			Gtwy	Interface		Destination		Session		Mach
Chan Enable		Appl.	To Mode	Link/Chan		Node	Port	Local/Remote		ID
1:	n	_______	_	__	_____	____________	0____	___	___	__
2:	n	_______	_	__	_____	____________	0____	___	___	__
:
31:	y	dcs____	c	3_	0 _	node-1______ 5003		31_	31_	1_
:
32:	y	dcs____	c	3_	0	node-1______ 6002		32_	32_	2_
:
256:	n	_______	_	__	_____	____________	0____	___	___	__

Note: The Processor Channel number, the Interface Channel number, and the Local and Remote Session numbers do not need to be the same number but they should be made the same whenever possible to simplify network “bookkeeping” and diagnostics.

> Enter values

Field	Conditions/Comments
For Processor Channel 31: (ethernet connection to Switch 1)
Enable	Set to y.
Appl.	Indicates that this connection will carry DCS data.
Mode	Node-3 is the “client” for this session. Set node-1 to
	“server” ( s).
Interface Link	This must match the link number assigned on the node-3
	data module screen.
Interface Chan	A value of 0 allows any available interface channel to be
	used for this connection. This number must match the
	Destination Port number on the Switch-1 Processor
	Channel screen.
Destination Node	Name of the far-end node for this channel. This must be a
	name entered on the Node Names screen.
	1 of 2

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	121