Lucent Technologies Release 8.2 manual Switch 1 Task Assign IP Interfaces

Configuration 2: R7r (+CMS) <—ethernet—> R7csi 3 C-LAN Administration

Switch 1 Task — Assign IP Interfaces

The IP interface for each C-LAN and MedPro board on the switch must be defined on the IP Interfaces form. Each DEFINITY switch in an IP network has one IP Interfaces form.

Steps

Begin

> Open IP Interfaces form — enter ch ip-i

change ip-interfaces				Page	1 of	2
		IP Interfaces
Inter-region IP connectivity allowed? n
Enable						Net
Eth Pt Type	Slot Code Sfx	Node Name	Subnet Mask	Gateway Addr		Rgn
y C-LAN	01c08 TN799 B	node-1	255.255.255.224 192.168.1_.97_ 1
n			255.255.255.0
n			255.255.255.0
n			255.255.255.0

> Enter values

Field	Conditions/Comments
Inter-region IP	Enter y to allow IP endpoints (phones and trunks) to use MedPro
connectivity	resources administered in regions that are different from the
allowed?	endpoints’ regions.
Enable Eth Pt	The Ethernet port must be enabled (y) before it can be used. The
	port must be disabled (n) before changes can be made to its
	attributes on this screen.
Type	Enter c-lan or medpro.
Slot	Enter the slot location for the circuit pack.
Code	Display only. This field is automatically populated with TN799
	for C-LAN or TN802 for MedPro.
Sfx	Display only. This field is automatically populated with B for
	the TN802 and TN799.
Node name	Enter the unique node name for the IP interface. The node name
	here must already be administered on the Node Names screen
	1 of 2

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	77