Lucent Technologies Release 8.2 manual Network uses 1’s

Configuration 5B: R8csi <—ppp—> R8r (2 C-LANs)	3 C-LAN Administration
<—ethernet—> R8si

Switch 3 Task — Assign Link via ethernet Data Module to the LAN

This task administers an ethernet data module on Switch 3 for the ethernet connection to Switch 1. The data module associates a link number with a port address, extension number, and node name for the C-LAN port used for this connection.

Steps

Begin

> Open Data Module form — enter a da n

add data next

					Page 1 of X
		DATA MODULE
Data Extension: 3901			Name: ethernet on link 1			BCC: 2
Type: ethernet
Port: 01a0517_
Link: 1
Network uses 1’s for broadcast addresses? y
	> Enter values
		Field		Conditions/Comments
		Type:		This indicates the data-module type for this connection.
		Port:		Ethernet connections must be assigned to port 17 on the
				C-LAN circuit pack.
		Link:		The link number must be in the range 1 – 25 (for R8si), not
				previously assigned on this switch.
		Name:		Information-only; appears in list generated by the "list data
				module" command.
		Network uses 1’s		Leave the default (y) if the private network contains only
		for broadcast		DEFINITY switches and adjuncts. Set to n only if the
		addresses?		network includes non-DEFINITY switches that use the 0’s
				method of forming broadcast addresses. See Appendix A,
				“Data Module - type ethernet” for more information about
				this field.
	> Submit the screen
	End

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	199