Lucent Technologies Release 8.2 manual How to administer Isdn Feature Plus

ISDN Feature Plus B Private Networking

ISDN Feature Plus

This feature allows you to have basic feature transparency over public networks without having a dedicated leased line. This provides a lower cost option for using the switched public network.

How to administer ISDN Feature Plus

Note: Only Lucent representatives perform step 1.

1On the System-Parameters Customer-Options form, set the:

~G3 Version field to V8.

~ISDN Feature Plus field to y.

2On the same form, set either or both of the following:

~ISDN-PRIfield to y, or

~ISDN-BRI Trunks field to y.

3Set either or both of the following:

~ISDN-BRI Trunk Group — Set the Supplementary Service Protocol field to f

~ISDN-PRI Trunk Group — Set the Supplementary Service Protocol field to f.

4On the Feature Related System Parameters form, set the Feature Plus Ext field to the local extension used to terminate Feature Plus signaling for ISDN Feature Plus.

5On the Hunt Group form, to add a centralized AUDIX, set the Message Center field to fp-mwi.

To start administration for Message Waiting Indication at the Message Center PBX:

1On the Feature Related System Parameters form, set the MWI - Number of Digits per AUDIX Subscriber field to the desired number.

2On the Processor Channel Assignment, set the Application field to fp-mwi.

3Administer the Message Waiting Indication Subscriber Number Prefixes form. To start the Calling Name feature:

4On the ISDN-BRI or ISDN-PRI trunk group form (whichever you are using), set the Send Name field to y.

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	355