Lucent Technologies Release 8.2 manual 168 CID

Configuration 5A: R8csi <—ppp—> R8r (one C-LAN)	3 C-LAN Administration
<—ethernet—> R8si

Switch 3 Task — Assign Processor Channels

This task associates data links with processor channels on Switch 3.

Steps

Begin

> Open the Processor Channel Assignment form — enter ch com p

change communications-interface processor-channels

Page 1 of X

PROCESSOR CHANNEL ASSIGNMENT

Proc			Gtwy	Interface		Destination		Session		Mach
Chan Enable		Appl.	To Mode	Link/Chan		Node	Port	Local/Remote		ID
1:	n	_______	_	__	_____	_________	0____	___	___	__
2:	n	_______	_	__	_____	_________	0____	___	___	__
:
31:	y	dcs ___	c	1_	0 __	node-1-eth 5003_		31_	13__	1_
32:	y	dcs ___	s	1_	5003_	node-2___ 0		32_	23_	2_
64:	n	_______	_	__	_____	_________	0____	___	___	__

> Enter values

Field

Conditions/Comments

Processor Channel 31: (ethernet connection to Switch 1)

Enable	Set to y.
Appl.	Set to dcs for DCS signaling.
Mode	Node-3 is the “client” for this session. Set node-1-eth to
	“server” ( s).
Interface Link	This must match the link number assigned on the node-3 data
	module screen.
Interface Chan	A value of 0 allows any available interface channel to be used
	for this connection. The Destination Port number on the
	Switch-1 Processor Channel screen must also be set to 0.
Destination	Name of the far-end node for this channel. This must be a name
Node	entered on the Node Names screen.
Destination	This number must match the Interface Channel number assigned
Port	on the Switch-1 Processor Channel screen.
	1 of 2

		Administration for Network Connectivity
168	CID: 77730	555-233-504 — Issue 1 — April 2000