Lucent Technologies Release 8.2 manual Wideband transmission

Configuration 3: R8si<—x.25 —> R8r Gateway	3 C-LAN Administration
<—ethernet—> R8si

Switch 2 Task — Assign Link via procr-intf Data Module to Switch 1

This task administers a processor-interface data module for the x.25 connection to node 1. The data module associates a link number with a physical channel number and extension number for the PI port used for this connection.

Steps

Begin
> Open Data Module form — enter						a da n
add data-module next
Page 1 of 1
			DATA MODULE
Data Extension: 4121					Name: _x.25 on link 2 to node-1__
Type: procr-intf				COS: 1		Maintenance Extension: 4191
Physical Channel: 02_				COR: 1		Destination Number: 8122102
ITC: Restricted				TN: 1		Establish Connection? n
Link: 2_			DTE/DCE: dce			Connected Data Module: _______
		Enable Link: n
ABBREVIATED DIALING
List1: _______________
SPECIAL DIALING OPTION: ________________
ASSIGNED MEMBER (Station with a data extension button for this data module)
Ext		Name
1.
> Enter values.
	Field				Conditions/Comments
	Type:				This indicates the data-module type for this
					connection.
	Physical Channel:				This must be the same as the link number.
	ITC:				Enter restricted. (unrestricted is used only for
					wideband transmission.)
	Link:				The link number must be in the range 1 –25 (for
					R8si), not previously assigned on this switch.
	Name:				Information-only; appears in list generated by the “list
					data module” command.
	COS:
					The values for these fields will be specified by the
	COR:
					system administrator.
	TN:
	DTE/DCE:				The DTE/DCE assignments must be opposites on the
					two ends of the connection. Use dte for node 1.
						1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000				CID: 77730		113