Briggs & Stratton 01653-4 manuel dutilisation Assembly, Unpacking the Generator, Install Wheel Kit

ASSEMBLY

ASSEMBLY

To install wheel kit you need the following tools:

• 15/16" (22mm) box, open end, or socket wrench

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at

1-800-743-4115. If calling for assistance, please have the model, revision, and serial number from the data tag available.

Unpacking the Generator

1.Set the carton on a rigid flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

Install Wheel Kit

The wheel kit is designed to greatly improve the portability of your generator.

NOTE: Wheel kit is not intended for over-the-road use.

•Two 13mm box, open end, or socket wrenches

•Two 10mm box, open end, or socket wrenches

Install Wheel Kit as follows: (Refer to Figure 1)

1.Tip generator so that engine end is up.

2.Place axle stud through mounting bracket on generator frame.

3.Use 15/16” wrench to secure the axle stud to frame with 5/8-18 jam nut.

4.Place wheel on axle stud.

NOTE: Be sure to install wheel with raised hub inboard.

5.Place flat washer over axle stud and fasten with retaining pin.

6.Repeat steps 2 through 5 for other wheel.

7.Tip generator so that engine side is down.

8.Attach the vibration mount to the support leg with a M6 X 16mm capscrew and M6 hex nut.

9.Remove two top nuts from vibration mount on unit with 13mm wrench. Use these nuts to attach the support leg.

Figure 1 — Installing the Wheel Kit

Capscrew
Handle		Axle Stud
Grip
Nut		Wheel
Nut	Jam Nut
Mounting Leg		Washer
	Use Existing Fasteners	Retaining Pin
Vibration Mount	to Secure Leg
	Capscrew
	6