Lucent Technologies Release 8.2 manual Switch 1 Task Assign Node Names, Steps

Configuration 1: R8r <—ppp—> R8si 3 C-LAN Administration

Switch 1 Task — Assign Node Names

This task assigns node names and IP addresses to each node in the network. This screen is administered on Switch 1. A Node Names screen must be administered on each switch in the network.

The node names and IP addresses in any network should be assigned in a logical and consistent manner from the point of view of the whole network. These names and addresses should be assigned in the planning stages of the network and should be available from the customer system administrator or from a Lucent representative.

Note: Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter node names for switches, routers, and CMS starting on page 2.

Steps

Begin

> Open Node Names screen — enter ch node-n> Go to page 2 of the screen

change node-names			Page	2 of 6
	NODE	NAMES
Name	IP Address	Name	IP Address
default___________ 0__.0__.0__.0__		__________________ ___.___.___.___
node-1____________ 192.168.10_.31_		__________________ ___.___.___.___
node-2____________ 192.168.10_.32_		__________________ ___.___.___.___
__________________	___.___.___.___	__________________	___.___.___.___

> Enter values.

Field	Conditions/Comments
Name	Enter unique node names for the following 2 nodes:
	•	C-LAN PPP port on Switch 1
	•	C-LAN PPP port on Switch 2.
IP Address	The unique IP addresses of the nodes named in the previous field.

> Submit the screen

End

		Administration for Network Connectivity
62	CID: 77730	555-233-504 — Issue 1 — April 2000