Lucent Technologies Release 8.2 manual 120 CID

Configuration 3: R8si<—x.25 —> R8r Gateway	3 C-LAN Administration
<—ethernet—> R8si

Switch 3 Task — Assign Link via ethernet Data Module to the LAN

This task administers an ethernet data module on Switch 3 for the ethernet connection to Switch 1. The data module associates a link number with a port address, extension number, and node name for the C-LAN port used for this connection.

Steps

Begin

> Open Data Module form — enter a da n

add data module next				Page 1 of x
	DATA MODULE
Data Extension: 4531		Name: ethernet on link 3			BCC: 2
Type: ethernet
Port: 01a1017
Link: 3_
Network uses 1’s for broadcast addresses? y
> Enter values.
	Field		Conditions/Comments
	Type:		This indicates the data-module type for this connection.
	Port:		In this example, the C-LAN circuit pack is in slot 01a10; the
			ethernet connection is through port 17.
	Link:		The link number must be in the range 1 – 25 (for R8si), not
			previously assigned on this switch.
	Name:		Information-only; appears in the “list data module” command list.
	Network		Leave the default (y) if the private network contains only
	uses 1’s for		DEFINITY switches and adjuncts. Set to n only if the network
	broadcast		includes non-DEFINITY switches that use the 0’s method of
	addresses?		forming broadcast addresses. See Appendix A, “Data Module -
			type ethernet” for more information about this field.

> Submit the screen

End

		Administration for Network Connectivity
120	CID: 77730	555-233-504 — Issue 1 — April 2000