Lucent Technologies Release 8.2 manual Add data module next

Configuration 3: R8si<—x.25 —> R8r Gateway	3 C-LAN Administration
<—ethernet—> R8si

Switch 1 Task — Assign Link via ethernet Data Module to the LAN

This task administers an ethernet data module for ethernet connections. The data module associates a link number with a port address, extension number, and node name for the C-LAN port used for this connection.

Steps

Begin

> Open Data Module form — enter a da n

add data module next		Page 1 of x
	DATA MODULE
Data Extension: 3391		Name: ethernet on link 3 BCC: 2
Type: ethernet
Port: 01b0117
Link: 3
Network uses 1’s for broadcast addresses? y
> Enter values.
	Field	Conditions/Comments
	Type:	This indicates the data-module type for this connection.
	Port:	In this example, the C-LAN circuit pack is in slot 01b01; the
		ethernet connection is through port 17.
	Link:	The link number must be in the range 1 – 33 (for R8r).
	Name:	Information-only; appears in list generated by the “list data
		module” command.
	Network	Leave the default (y) if the private network contains only
	uses 1’s for	DEFINITY switches and adjuncts. Set to n only if the network
	broadcast	includes non-DEFINITY switches that use the 0’s method of
	addresses?	forming broadcast addresses. See Appendix A, “Data Module -
		type ethernet” for more information about this field.

> Submit the screen

End

		Administration for Network Connectivity
108	CID: 77730	555-233-504 — Issue 1 — April 2000