Lucent Technologies Release 8.2 manual Switch 2 Task Assign Link via ppp Data Module to Switch

Configuration 1: R8r <—ppp—> R8si 3 C-LAN Administration

Switch 2 Task — Assign Link via ppp Data Module to Switch 1

This task administers a ppp data module on Switch 2 for the ppp connection to Switch

1.The data module defines a network interface — it associates a link number with a port address and node name for the C-LAN port on Switch 2. It also specifies the node name for the destination node, which is a C-LAN port on Switch 1.

Steps

Begin

>Open Data Module form — enter ad da n

add data-module next
						Page 1 of x
					DATA MODULE
Data Extension: 3020					Name: _ppp on link 3 to node-1___ BCC: 2
Type: ppp					COS: 1
Port: 01a1206					COR: 1
Link: 3_					TN: 1
Enable Link? n
Node Name: node-2_			____
Subnet Mask: 255.255.255.0
Establish Connection: n
DESTINATION
Digits:		__________
Node Name: node-1_________
CHAP? n
[This data module is assigned the next available extension, 3020.]
>Enter values
	Field			Conditions/Comments
	Type:			This indicates the data-module type for this link.
	Port:			In this example, the C-LAN circuit pack is in slot 01a12; the ppp
				connection is through port 06.
	Link:			The link number must be in the range 1 – 25, not previously
				assigned on this switch.
	Enable Link?			If you need to add an IP route that uses this node as a gateway,
				this field must be set to y before adding the IP route. Otherwise
				leave this field set to n until the link administration is complete;
				that is, until after all data modules and the processor channels
				are assigned, then set to y.
	Name:			Information-only; appears in list generated by the “list data
				module” command.
						1 of 2
						Administration for Network Connectivity
68					CID: 77730	555-233-504 — Issue 1 — April 2000