Lucent Technologies Release 8.2 manual Task 6 Modify signaling group, Enter values, Task 6 Steps

H.323 Trunk Administration 2 H.323 Trunks

Task 6 — Modify signaling group

This task modifies the signaling group form to add a trunk group number to the Trunk

Group for Channel Selection field.

Task 6 Steps

	Begin
	> Busy out the signaling group — enter			bu sig 3
	> Open the Signaling Group form — enter ch sig 3
change signaling-group 3					Page	1 of 5
		SIGNALING GROUP
Group Number: 3		Group Type: h.323		Max number of NCA TSC: 0
				Max number of CA TSC: 0
Trunk Group for Channel Selection: 3				Trunk Group for NCA TSC:
Supplementary Service Protocol: a
Near-end Node Name: clan-a1			Far-end Node Name: clan-b1
Near-end Listen Port: 1720			Far-end Listen Port: 1720
LRQ Required? n			Calls Share IP Signaling Connection? n
			Bypass If IP Threshold Exceeded? n
	> Enter values
	Field		Conditions/Comments
	Trunk Group for Channel		Enter the trunk group number. If there is more than
	Selection		one trunk group assigned to this signaling group, the
			group entered in this field will be the one that can
			accept incoming calls.
	> Submit the screen
	> Release the signaling group — enter			rel sig 3.
	End

		Administration for Network Connectivity
48	CID: 77730	555-233-504 — Issue 1 — April 2000