H.323 Trunk Administration2 H.323 Trunks

Task 5 — Create a trunk group

This task creates a new trunk group for H.323 trunks. Each H.323 trunk must be a member of an ISDN trunk group and must be associated with an H.323 signaling group.

Note: The following steps address only those fields that are specifically related

 

to H.323 trunks. The other fields are administered as for previous releases

 

and are described in the Administrator’s Guide.

 

 

Task 5 Steps

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Begin

 

 

 

 

 

 

 

> Open new Trunk Group form — enter a tr n

 

 

 

 

 

 

 

 

 

 

add trunk-group n

 

 

 

 

 

Page 1 of 10

 

 

TRUNK GROUP

 

 

 

Group Number: 3

Group Type: isdn

CDR Reports: y

Group Name: TG 3 for H.323 trunks

COR: 1

TN: 1

TAC: 103

Direction: two-way

Outgoing Display? n

Carrier Medium: IP

Dial Access? n

Busy Threshold: 99

Night Service:

Queue Length: 0

 

 

 

 

 

 

Service Type: tie

Auth Code? n

TestCall ITC: rest

 

Far End Test Line No:

 

 

 

TestCall BCC: 0

 

 

 

 

 

 

TRUNK PARAMETERS

 

 

 

 

 

 

Codeset to Send Display: 0

Codeset to Send National IEs: 6

Max Message Size to Send: 260

Charge Advice: none

 

Supplementary Service Protocol: a

Digit Handling (in/out): enbloc/enbloc

Trunk Hunt: cyclical

 

 

QSIG Value-Added Lucent? n

 

 

 

 

 

Digital Loss Group: 13

Calling Number - Delete:

Insert:

 

 

Numbering

Format:

Bit Rate: 1200

Synchronization: async

Duplex: full

Disconnect Supervision - In? y Out? n

 

 

 

 

 

Answer Supervision Timeout: 0

 

 

 

 

 

 

 

 

 

 

 

 

 

 

> Enter values

 

 

 

 

 

 

 

 

 

 

 

 

 

Field

 

 

 

Conditions/Comments

 

 

 

 

 

 

 

 

Group Type

 

 

Enter isdn.

 

 

 

 

 

 

 

 

 

 

Carrier Medium

 

 

Enter ip.

 

 

 

 

 

 

 

 

 

 

Service Type

 

 

Enter tie.

 

 

 

 

 

 

 

 

TestCall ITC:

 

 

Enter unre (unrestricted).

 

 

 

 

 

 

 

 

TestCall BCC:

 

 

Enter 0.

 

 

 

 

 

 

 

 

 

 

Codeset to Send Display

 

 

Enter 0.

 

 

 

 

 

 

 

Note: Outgoing Display

 

This field may need to be changed if the

 

 

 

 

 

far-end is a non-DEFINITY switch.

 

 

 

 

 

 

 

 

Administration for Network Connectivity

 

 

555-233-504 — Issue 1 — April 2000

CID: 77730

45

Page 65
Image 65
Lucent Technologies Release 8.2 manual Task 5 Create a trunk group, Trunk Administration2 H.323 Trunks, Task 5 Steps