Lucent Technologies Release 8.2 manual To CMS

Configuration 2: R7r (+CMS) <—ethernet—> R7csi 3 C-LAN Administration

Switch 1 Task — Assign Processor Channels

This task associates data links (hardware) with processor channels (software) on the node 1 switch.

Steps

Begin

> Open the Processor Channel Assignment form — enter ch com p

change communications-interface processor-channels

Page 1 of X

PROCESSOR CHANNEL ASSIGNMENT

Proc			Gtwy	Interface		Destination		Session		Mach
Chan Enable Appl.			To Mode	Link/Chan		Node	Port	Local/Remote		ID
1:	y	mis____	s	2_	5001__	node-2____	0____	1 _	1_	__
2:	n	_______	_	__	_____	__________	0____	___	___	__
3:	n	_______	_	__	_____	__________	0____	___	___	__
4:	n	_______	_	__	_____	__________	0____	___	___	__
:
12:	y	dcs ___	s	2_	5003__ node-5____		0____	12_	21_	2_
:
64:	n	________	_	__	_____	__________	0____	___	___	__

> Enter values

Field

Conditions/Comments

Processor Channel 1: (connection to CMS)

Enable	Set to y.
Appl.	Enter mis for the CMS connection on Processor Channel 1.
Mode	Set the Mode to s (“server”) on both switches for connections
	to CMS.
Interface Link	This must match the link number assigned on the node-1 data
	module screen.
Interface Chan	For TCP/IP, interface channel numbers are in the range 5000
	– 64500.
	The recommended values are: 5001 for CMS, 5002 for Intuity
	AUDIX, and 5003 for DCS connections that are not
	gateways. These three values should be reused for multiple
	instances of these applications; for example, if there are two
	Intuity AUDIX’s, use 5002 for both; or if there are four
	DEFINITY ECS’s, use 5003 for all four. The combination of
	Link, Interface Channel, and Mach ID must be unique.
	The recommended values for gateway switches is 6001–6099.
	The interface channel number must be unique for each
	gateway.
	1 of 3

		Administration for Network Connectivity
80	CID: 77730	555-233-504 — Issue 1 — April 2000