Lucent Technologies Release 8.2 manual Switch 3 Task Assign Node Names, Enter values

Configuration 3: R8si<—x.25 —> R8r Gateway	3 C-LAN Administration
<—ethernet—> R8si

Switch 3 Task — Assign Node Names

This task assigns node names and IP addresses to each node in the network. This screen is administered on Switch 3. A Node Names screen must be administered on each switch in the network.

The node names and IP addresses in any network should be assigned in a logical and consistent manner from the point of view of the whole network. These names and addresses should be assigned in the planning stages of the network and should be available from the customer system administrator or from a Lucent representative.

Note: Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter node names for switches, routers, and CMS starting on page 2.

Steps

Begin

> Open Node Names form — enter ch node-n> Go to page 2.

change node-names

					Page 2 of 6
			NODE NAMES
Name		IP Address		Name	IP Address
default__________ 0__.0__.0__.0__				_______________	___.___.___.___
node-1 _	_	192.168.10_.1__		_______________	___.___.___.___
node-3____		192.168.10_.3__		_______________	___.___.___.___
________________		___.___.___.___		_______________	___.___.___.___
		> Enter values.
		Field		Conditions/Comments
		Name		Enter unique node names for the following 2 nodes:
				• C-LAN Ethernet port on Switch 3
				• C-LAN Ethernet port on Switch 1.
		IP Address		The unique IP addresses of the nodes named in the previous
				field.
		> Submit the screen
		End

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	117