Lucent Technologies Release 8.2 Trunk Administration Task Summary, Described in the next section

H.323 Trunk Administration 2 H.323 Trunks

H.323 Trunk Administration — Task Summary

After the enabling administration is complete, you can administer the H.323 IP trunks. The screens and fields that need to be administered are listed below.

	NOTE: This is only a list of screens and the fields that need to be
	administered. The values that need to be entered in these fields are
	described in the next section.
Node names	A node name and IP address must be entered on the Node Names screen for each
	C-LAN and IP Interface board on the local switch. For each far-end node that the
	H.323 trunks on the local switch will connect to, a node name and IP address must be
	entered for the far-end gatekeeper, which is a C-LAN board if the far-end is a
	DEFINITY switch. Enter values in these fields:
	~	Node Name
	~	IP Address
IP Interfaces	Each DEFINITY switch in an IP network has one IP Interfaces screen. One line on
	this screen must be administered for each C-LAN and each IP Interface board. Enter
	values in these fields:
	~ Network regions are interconnected?
	~	Enable
	~	Type
	~	Slot
	~	Code
	~	Sfx
	~	Node Name
	~	Subnet Mask
	~	Default Gateway Address
	~	Region

Ethernet Data Module A data module screen, type ethernet, must be administered for each C-LAN board on the switch. Enter values in these fields:

~Type

~Port

~Link

~Name

~Network uses 1’s for broadcast address?

		Administration for Network Connectivity
36	CID: 77730	555-233-504 — Issue 1 — April 2000