Lucent Technologies Release 8.2 Plan call routing, Off-Premise Dialing at Remote Site, NT Tasks

IP Trunk Administration	F IP Trunk Installation and
	Administration

NT Tasks

•Log on to Windows NT and start the IP Trunk service

•Use the Configuration Manager to administer the routes and dialing permissions you defined on the Dial/Routing Plan worksheets or the procedures for extension dialing between sites.

•Use the Configuration Manager to set the IP Trunk service parameters

Plan call routing

Using the Procedures for Extension Dialing Between Sites

Using the Dial/Routing Plan Worksheets

Use the IP Trunk worksheets (shown at the end of this appendix) and/or the Procedures for Extension Dialing Between Sites to plan and coordinate your IP Trunk administration in Configuration Manager and DEFINITY ECS switch administration software.

You will create a dialing and routing plan, then use the information to administer DEFINITY ECS and the IP Trunk application. Read and follow these instructions carefully.

Follow these procedures for administering extension dialing between several sites. This section includes the steps for administration as well as examples using three sites that show DCS and non-DCS scenarios.

The worksheets are used for any two-site configuration allowing off-premise dialing. Worksheet 1 is used to capture general information about your site.

Worksheets 2–8 are used for different levels of off-premise dialing restrictions at the remote site, as listed in the following table.

Off-Premise Dialing at Remote Site:

Worksheet 2: No off-premise dialing at remote site.

Worksheet 3: any exchange

Same Area Code

Worksheet 4: only exchange X

Worksheet 5: any area code

Same Country

Worksheet 6: only area code X

Worksheet 7: any different country

Worksheet 8: only different country X

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	419