Lucent Technologies Release 8.2 manual Go to page 2 of the screen, Field Conditions/Comments

H.323 Trunk Administration					2 H.323 Trunks
	Task 1 Steps
	Begin
	> Open Node Names screen — enter		ch node-n
	> Go to page 2 of the screen
	change node-names				Page 2 of 6
		NODE NAMES
	Name	IP Address		Name	IP Address
	clan-a1______	192.168.10_.31_ ___________			___.___.___.___
	clan-a2______	192.168.20_.31_		___________	___.___.___.___
	default	0 .0 .0	.0	___________	___.___.___.___
	medpro-a1___	192.168.10_.81_ ___________			___.___.___.___
	medpro-a2___	192.168.20_.81_ ___________			___.___.___.___
	medpro-a3___	192.168.10_.82_ ___________			___.___.___.___
	medpro-b1___	192.168.10_.83_ ___________			___.___.___.___
	___	___.___.___.___		___________	___.___.___.___

> Enter values.

Field	Conditions/Comments
Name	Enter unique node names for:
	• Each C-LAN ethernet port on the network
	• Each IP-Interface (Medpro) board on the local switch.
	The default node name and IP address is used to set up a default
	gateway, if desired. This entry is automatically present on the Node
	Names screen and cannot be removed.
	When the Node Names screen is saved, the system automatically
	alphabetizes the entries by node name.
IP Address	Enter a unique IP addresses for each node named in the previous
	field.

> Submit the screen

End

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	39