Lucent Technologies Release 8.2 manual Switch 1 Task Assign Processor Channels

Configuration 4: R8csi <—ISDN—> R8si Gateway	3 C-LAN Administration
<—ppp—> R8csi

Switch 1 Task — Assign Processor Channels

This task associates data links (hardware) with processor channels (software) on the node 1 switch.

Steps

Begin

> Open the Processor Channel Assignment form — enter ch com p

change communications-interface processor-channels

Page 1 of X

PROCESSOR CHANNEL ASSIGNMENT

Proc			Gtwy		Interface	Destination		Session		Mach
Chan Enable		Appl.	To Mode	Link/Chan		Node	Port	Local/Remote		ID
1:	n	_______	_	__	_____	__________	0____	___	___	__
2:	n	_______	_	__	_____	__________	0____	___	___	__
:
13:	y	dcs ___	s	1_	5003_	node-3____ 0		13__	31_	3_
14:	y	gateway	s	1_	6002_	node-3____	0	14__	32_	__
:
64:	n	_______	_	__	_____	__________	0____	___	___	__

> Enter values

Field

Conditions/Comments

Processor Channel 13: (ppp connection to Switch 3)

Enable	Set to y.
Appl.	Set to dcs for DCS signaling.
Mode	Node-1 is the “server” for this session. Set node-3 to “client”
	(c).
Interface Link	This must match the link number assigned on the node-1 data
	module screen.
Interface Chan	For TCP/IP, interface channel numbers are in the range 5000 –
	64500.
	The recommended values are: 5001 for CMS, 5002 for Intuity
	AUDIX, and 5003 for DCS connections that are not gateways.
	These three values should be reused for multiple instances of
	these applications; for example, if there are two Intuity
	AUDIX’s, use 5002 for both; or if there are four DEFINITY
	ECS’s, use 5003 for all four. The combination of Link, Interface
	Channel, and Mach ID must be unique.
	This number must match the Destination Port number on the
	node-3 Processor Channel screen.
	1 of 3

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	129