Lucent Technologies Release 8.2 manual Switch 3 Task Assign IP Interfaces

Configuration 5A: R8csi <—ppp—> R8r (one C-LAN)	3 C-LAN Administration
<—ethernet—> R8si

Switch 3 Task — Assign IP Interfaces

The IP interface for each C-LAN board on the switch must be defined on the IP Interfaces form. Each DEFINITY switch in an IP network has one IP Interfaces form.

Steps

Begin

> Open IP Interfaces form — enter ch ip-i

change ip-interfaces				Page	1 of	2
		IP Interfaces
Inter-region IP connectivity allowed? n
Enable						Net
Eth Pt Type	Slot Code Sfx	Node Name	Subnet Mask	Gateway Addr		Rgn
y C-LAN	01a05 TN799 B	node-3	255.255.255.0	192.168.10_.128 . 1
n			255.255.255.0
n			255.255.255.0
n			255.255.255.0

> Enter values

Field	Conditions/Comments
Inter-region IP	Enter y to allow IP endpoints (phones and trunks) to use
connectivity	MedPro resources administered in regions that are
allowed?	different from the endpoints’ regions.
Enable Eth Pt	The Ethernet port must be enabled (y) before it can be
	used. The port must be disabled (n) before changes can be
	made to its attributes on this screen.
Type	Enter c-lan or medpro.
Slot	Enter the slot location for the circuit pack.
Code	Display only. This field is automatically populated with
	TN799 for C-LAN or TN802 for MedPro.
Sfx	Display only. This field is automatically populated with B
	for the TN802 and TN799.
Node name	Enter the unique node name for the IP interface. The node
	name here must already be administered on the Node
	Names screen
	1 of 2

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	165