basic saw operation
REPETITIVE CUTTING
REPETITIVE CUTTING is known as cutting a quantity of pieces the same length without having to mark each
piece.
1.Use the Stop Rods (optional accessory) only for cutting duplicate pieces 6 inches long and longer.
2.Foitow all safety precautions and operational instruc- tions for cross cutting.
When making repetitive cuts from a long workpiece, make sure it is adequately suppoded.
Use the
i | i |
3.NEVER USE THE RIP FENCE AS A LENGTH STOP BECAUSE THE
4.When making repetitive cuts shorter than 6 inches, clamp a block ofwood 2 inches long to the table to act as a length stop. Do not clamp directly to the bottom edge of the table because the "swivel" of the clamp will not grip properly. Place a small block of wood between the bottom edge of the table and the "C" clamp,
CAUTION: When clamping the block, make sure that the end of the block Is well In front of the
sawblade. Be sure it is clamped securely.
5.SrK:lethe workpiece along the Miter Gauge unt_ it touches the block, hold itsecurely or clamp itwith the
6.Make the cut, pull the workpiece back, turn the saw off, wait for Blade to stop and remove cut off piece
before continuing.
=
MITER cu'ri'ING
MITER CUTTING is known as cutting wood at an angle other than 90 ° with the edge of the wood. Follow the same procedure as you would for crosscutting.
Adjust the Miter Gauge to the desired angle, and lock it. The Miter Gauge may be used in either ofthe grooves in
the table.
When using the Miter Gauge in the LEFT hand groove,
hold the wo_ece firmly against the Miter Gauge head with your left hand, and gdp the Lock Handle with your
right.
Whenusing the RIGHThandgroove, holdthe workplece with your right hand and the Knob with your lefl hand.
Use the
LEFT HAND REMOVED "\ FOR PICTURE CLARITY \
WORK SUPPORT
32
