Craftsman 113.298721, 113.298761 manual Instalung Belt, assembly

assembly

5.From among the loose parts, find the following hardware:

*4 Carriage Bolts, 5/16-18 x 3/4

*4 Hex Nuts 5t16-18

*4 Lockwashers, 5/16 External Type

1 Motor Pulley

1 Belt Guard "L" Bracket

1 Belt Guard Support Bracket

Items marked with an asterisk (*) are shown actual size.

= == i ,=,,,,,H i , i= ,1=

POSITIONING MOTOR ON MOTOR MOUNTING BASE

Model 113.298761

1.Put the motor mounting base against the flat surface of a workbench.

2.Positionthe motor so the end with terminal cover is facing you.

3.Loosen both cradle clamp screws.

4.Put a square against the LEFT side of the motor and against the top of the workbench.

5.Turn the motor inside the cradle clamps until the top of both capacitors touch the square

6.Tighten bothcradle clamp screwsIo hold the motor in this position.

WARNING: Failure to properly Install motor may let workplece strike capacitor cover during bevel or compound miter cuts.

=l

MOUNTING MOTOR ON MOTOR BASE

Model 113.298721 & 113.298761

1.Place Motoron MotorBase so that shaft is pointing to the right. Insert bolts through holes in Base, then through the Motor MountingBase. Installlockwashers and nuts, DO NOT TIGHTEN AT THIS TIME.

2.Position Motor so that edge of Motor Foot and Motor Base are even. Slide Motor allthe way to the RIGHT. Slip the long part of the "L" Bracket fully under the Motor so the short part is just under shaft (Model 113.298721 only). Tighten the fournuts.

away from Motor. DO NOTTIGHTEN SETSCREW.

4.Install 3116 inchsquare key (furnished with Motor) in groovesin PulleyandMotorshaft. DONOTTIGHTEN

SETSCREW.

, = =

INSTALUNG BELT

Model 113.298721 & 113.298761

1.Lift Motor and insert the TWO PINS on Motor Base into HOLES in Cradle. Push Motor in as far as itwill

go.

_BELT GUARdeD

BELTGUARDMOTOR SUPPORT BRACKET

"L_BRACKETPULLEY

5/16-18 x 3/4 IN 5/16-18 5/16 IN EXTERNAL

CARRIAGE BOLT HEX NUT LOCKWASHER

LOOSEN BOTH CRADLE CLAMP SCREWS

r.---

CAPACITORS"	MOTOR
	MOTOR MOUNTING
SQUARE	BASE
	WORK BENCH

WELDED MOTOR

MOUNTING BASE

THESE TWO CARRIAGE BOLT

EDGES EVEN 5116-18 X 3/4 iN.

LOCKWASHER 5/16 IN.

5/16-18

BELT GUARD SUPPORT "" PULLEY

INSERTED EVEN WITH

MOTOR END HUB

2.Lowerthe blade, install Belt on Saw Pulley and Motor Pulley.

3.Sight along edges of both pulleys and move Motor Pulley so that belt is parallel to the edges of bol Pulleys. Tighten the set screw in the Motor Pulley.

22