Craftsman 113.298721, 113.298761 manual assemby, O.Ex.Ut

assemby

6.Insert Spreader Rod into Spreader Support until pin fits into notch. Insert Thumbscrew and tighten it.

7.Slide Spreader Rod into Blade Guard Support until end of Rod is even with edge of Support. Tighten

Hex Head Screw in Support.

8.Attach Spreader to Spreader Support so that the edge of the Spreader is ever_with the edge of the Spreader Support. Tighten screws.

9.Raise Anti-Kickback Pawls (hold in place with a set- screw wrench - see below). AlignSpreader SQUARE to table,

Tighten both 5/16-18 x 1 inch Hex Head Screws.

10.Raise blade all the way up, make sure it is square with table.

11.Raise Blade Guard. Lift up both Anti-Kickback Pawls. Insert one of the Setscrew Wrenches in the notches to hold the Pawlsout of the way.

13.Loosen Hex Head Screw in Guard Support and move Spreader so that it touches blade of square. Tighten screw.

THUMB	SCREW
	\
SPREADER	\
ROD
\
\
FLAT
SURFACE		SPREADER
\ (INTO SUPPORT)		SUPPORT

17 "

U

1/-2ONE\	I	II II	_L-""-.-.._
HD. SCREW	___\			I_'__
114 IN. LOCKWASHER	_	II I.j'_Trr'"		\ /l_";)		_J/.i/"	I	t
,,,-,O.EX.UT				'/I
SPREADER EDGE f	I	II	"_.%'_	, _t_J	\\	v_l		I
EVEN WITH SPREADER I		U	_h_'_	\/_--II	\\	\\	_1	I
EmDOFROD			- _	,J,/_-'<'-"_---_A\ I				I
EVEN WiTH		EDGE		_ _._=1 _	_.._._		I	[

HE\ HD.

SCREW