assembly
Before mountingthe saw on legs, a stand or a bench, the
Table Insert and Blade Squareness must be checked at this time.
INSTALLING HANDWHEELS
1.Line up FLAT SPOTS on shaft and Handwheel, push Handwheel onto shaft. Install screw and Iockwasher to lock Handwheel on shaft.
LOCKWASHER
| X 314 IN. | |
| PHILLIPS | |
ELEVATION | HEAD | SCREW |
TILT HANDWHEEL |
| |
HANDWHEEL |
| |
CHECKING TABLE INSERT
1.Insert should be flush with table top, Check as shown. Loosen flat head screw that holds Insert and
adjust the four set screws as necessary.
3/32 IN
SETSCREW WRENCH
2.To remove Insert. A. Loosen Screw
B Lift Insert from front end, and pull toward front of
saw,
3, To replaceinsert.
A. Place Insert into insert opening in table and push toward rear of saw to engage spring clip and until keyslot in insert will drop over screw. Tighten
screw.
B. Do not tighten screw to the point where it will deflect the Insert.
CHECKING BLADE SQUARENESS TO
TABLE
IMPORTANT: BLADE must be SQUARE (90 °) to TABLE, in order to proceed with assembly.
1."rum Elevation Handwheelclockwise until blade isup
2.Check for BLADE SQUARENESS. If blade is not square to table, adjust it at this time,
Contents" section
Refer to "Blade Tilt, or Squareness of Blade to Table" adjustment on page 39.
MAKESURESQUARE ISNOTTOUCHING
TIPOFTOOTH
/
/
10
