Read all Instructions

WARNING:

• DO NOT attempt to charge the battery pack with any chargers other than the ones in this manual. The charger and battery pack are specifically designed to work together.

• These chargers are not intended for any uses other than charging designated Black & Decker rechargeable batteries. Any other uses may result in risk of fire, electric shock or electrocution.

• WARNING: The charger supplied with this product is intended to be plugged in such that it is correctly orientated in a vertical or floor mount position.

• Do not expose charger to rain or snow.

• Pull by plug rather than cord when disconnecting charger. This will reduce risk of damage to electric plug and cord.

• Make sure that cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

• Do not use an extension cord unless it is absolutely necessary. Use of improper extension cord could result in risk of fire, electric shock, or electrocution.

• Do not place any object on top of charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source. The charger is ventilated through slots in the top and the bottom of the housing.

• Do not mount charger on wall or permanently affix charger to any surface. The charger is intended to use on a flat, stable surface (i.e., table top, bench top).

• Do not operate charger with damaged cord or plug — have them replaced immediately.

• Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take it to an authorized service center.

• Do not disassemble charger; take it to an authorized service center when service or repair is required. Incorrect reassembly may result in a risk of electric shock, electrocution or fire.

• Disconnect the charger from the outlet before attempting any cleaning. This will reduce the risk of electric shock. Removing the battery pack will not reduce this risk.

• NEVER attempt to connect 2 chargers together.

• The charger is designed to operate on standard household electrical power (120 Volts). Do not attempt to use it on any other voltage.

Important safety InstructIons for battery packs

WARNING: For safe operation, read this manual and manuals originally supplied with tool before using the charger.

The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below. Then fol- low charging procedures outlined.

• Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The battery pack can explode in a fire. Toxic fumes and materials are created when battery packs are burned.

• Do not charge or use battery in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing the battery from the charger may ignite the dust or fumes.

• If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte for Li-ion batteries is composed of a mixture of liquid organic carbonates and lithium salts.

• Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.

WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or flame.

• Charge the battery packs only in Black & Decker chargers.

• DO NOT splash or immerse in water or other liquids. This may cause premature cell failure.

• Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 105°F (40˚C) (such as outside sheds or metal buildings in summer).

WARNING: Never attempt to open the battery pack for any reason. If battery pack case is cracked or damaged, do not insert into charger. Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has received a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Damaged battery packs should be returned to service center for recycling.

WARNING: Fire hazard. Do not store or carry battery so that metal objects can contact exposed battery terminals. For example, do not place battery in aprons, pockets, tool boxes, product kit boxes, drawers, etc., with loose nails, screws, keys, etc. Transporting batteries can possibly cause fires if the battery terminals inadvertently come in contact with conductive materials such as keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material Regulations (HMR) actually prohibit transporting batteries in commerce or on airplanes (i.e., packed in suitcases and carry-on luggage) UNLESS they are properly protected from short circuits. So

when transporting individual batteries, make sure that the battery terminals are protected and well insulated from materials that could contact them and cause a short circuit. NOTE: Batteries should not be put in checked baggage.

Storage Recommendations

1. The best storage place is one that is cool and dry away from direct sunlight and excess heat or cold.

2. Long-term storage will not harm the battery pack or the charger as long as the battery is not depleted..

Charging Procedure

Black and Decker chargers are designed to charge Black and Decker battery packs: LCS36 (2 hrs), LCS436 (6 hrs).

1. Plug the charger into an appropriate outlet before inserting the bat- tery pack.

2. Insert the battery pack into the charger.

3. The green LED will flash indicating that the battery is being charged.

4. The completion of charge is indicated by the green LED

remaining on continuously. The pack is fully charged and may be used at this time or left on the charger.

Recharge discharged batteries as soon as possible after use or bat- tery life may be greatly diminished.

Charger Diagnostics

This charger is designed to detect certain problems that can arise with the battery packs or the power source. Problems are indicated by one LED flashing in different patterns.

Bad battery

The charger can detect a weak or damaged battery. The red LED flashes in the pattern indicated on the label. If you see this

bad battery blink pattern, do not continue to charge the battery. Return it to a service center or a collection site for recycling.

Hot/Cold pack delay

When the charger detects a battery that is excessively hot or

excessively cold, it automatically starts a Hot/Cold Pack Delay,

suspending charging until the battery has normalized. After this happens, the charger automatically switches to the Pack Charging mode. This feature ensures maximum battery life. The red LED flashes in the pattern indicated on the label when the hot / cold pack delay is detected.

Leaving the battery in the charger

The charger and battery pack can be left connected with the green LED glow- ing indefinitely. The charger will keep the battery pack fresh and fully charged.

Important Charging Notes
1. Longest life and best performance can be obtained if the battery
pack is charged when the air temperature is between 60°F and 80°F
(16°- 27°C). DO NOT charge the battery pack in an air temperature
below +40°F (+4.5°C), or above +105°F (+40.5°C). This is important
and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch while
charging. This is a normal condition, and does not indicate a problem.
To facilitate the cooling of the battery pack after use, avoid placing
the charger or battery pack in a warm environment such as in a metal
shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other appliance
b. Check to see if receptacle is connected to a light switch
which turns power off when you turn out the lights.
c. Move charger and battery pack to a location where the surrounding
air temperature is approximately 60°F - 80°F (16° - 27°C).
d. If charging problems persist, take the tool, battery pack and
charger to your local service center.
4. The battery pack should be recharged when it fails to produce suf-
ficient power on jobs which were easily done previously. DO NOT
CONTINUE to use under these conditions. Follow the charging proce-
dure. You may also charge a partially used pack whenever you desire
with no adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited to,
steel wool, aluminum foil, or any buildup of metallic particles should be
kept away from charger cavities. Always unplug the charger from the
power supply when there is no battery pack in the cavity. Unplug char-
ger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WARNING: Shock hazard. Do not	B	B1
allow any liquid to get inside charger.	B
Never attempt to open the battery pack	B2
for any reason. If the plastic housing of
the battery pack breaks or cracks, return
to a service center for recycling.
State of charge indicator
(figure B)
The battery is equipped with a state of
charge indicator. This can be used to
display the current level of charge in the
battery while in the mower and during

CM1640 specifications

The Black & Decker CM1640 is a versatile and user-friendly corded electric lawn mower that offers gardeners a reliable option for maintaining an immaculate lawn. This mower is equipped with a powerful 16-inch cutting deck that effectively handles small to medium-sized yards, making it a suitable choice for homeowners with varying lawn sizes.

One of the standout features of the CM1640 is its lightweight design, which weighs in at just under 40 pounds. This allows for easy maneuverability around tight spaces and ensures that users can navigate their lawns with minimal physical strain. The folding handles add further convenience, as they allow for compact storage when the mower is not in use.

The CM1640 incorporates a 6-setting height adjustment feature, making it easy for users to customize the cutting height according to their preferences and lawn conditions. This flexibility ensures that the mower can handle a variety of grass types, promoting a healthy and visually appealing yard. Additionally, the mower features a 12-amp motor that provides ample power to cut through thick grass effortlessly.

Another noteworthy characteristic of the Black & Decker CM1640 is its maintenance-free operation. The electric motor eliminates the need for gas, oil, and filters, making it an environmentally friendly option that also reduces the hassle of traditional lawn mower upkeep. This eco-conscious approach is complemented by its quiet operation, allowing users to mow without disturbing the peace of their neighborhood.

In terms of technology, the CM1640 showcases a durable polymer deck that resists rust and corrosion, extending the life of the mower. The mower is designed with a bagging system that efficiently collects grass clippings, ensuring a clean finish and making post-mowing cleanup quick and easy.

Overall, the Black & Decker CM1640 combines power, ease of use, and eco-friendliness, making it an excellent choice for homeowners looking to maintain their lawns with ease. With its thoughtful design and robust features, this electric mower is engineered to meet the demands of modern gardening while promoting a low-maintenance lifestyle. Whether you are an experienced gardener or a novice, the CM1640 is equipped to make your lawn care tasks more manageable and enjoyable.

Black & Decker CM1640 Read all Instructions, Important safety InstructIons for battery packs

Models: CM1640

Important safety InstructIons for battery packs