the discharge guard frequently and when necessary replace with Black+Decker recommended parts only.
9. Mower blades are sharp. Wrap the blade or wear gloves, and use extra caution when servicing them.
10.Maintain or replace safety and instruction labels, as necessary.
This Class B digital apparatus complies with Canadian
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and the receiver.
. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This Class B digital apparatus complies with Canadian
save these instructions
WARNING: GENERAL
SAFETY WARNINGS AND INSTRUCTIONS FOR ALL TOOLS
• THIS TOOL CAN BE DANGEROUS. Follow all warnings and Safety Instructions in this manual. The
operator is responsible for following warnings and instructions in this manual and on unit. Restrict use of this mower to persons who read, understand and follow warnings and instructions in this manual and on unit.
• Avoid dangerous environment – don’t use lawn mowers in damp or wet locations.
• Don’t Use In Rain.
• Keep Children Away – All visitors should be kept a safe distance from work area.
• Dress Properly – Do not wear loose clothing or jewelry. They can be caught in moving parts. Use of rubber gloves and footwear is recommended when working outdoors.
• Use Safety Glasses – Always use face or dust mask if operation is dusty.
• Use Right Appliance – Do not use lawn mower for any job except that for which it is intended.
• Use of Extension Cords Make sure the extension cord is in good condition before using. Always use the proper size extension cords with the tool – that is, proper wire size for various lengths of cord and heavy enough to carry the current the tool will draw. Use of an undersized cord will cause a drop in line voltage resulting
|
| Minimum Gage for Cord Sets |
| ||
Volts |
| Total Length of Cord in Feet | |||
120V |
| ||||
|
| ||||
Ampere Rating |
| American Wire Gage | |||
More Not more |
| ||||
Than | Than | 18 | 16 | 16 | 14 |
0 | |||||
6 | 18 | 16 | 14 | 12 | |
10 | 16 | 16 | 14 | 12 | |
12 | 14 | 12 | Not Recommended | ||
|
|
|
|
|
|
in loss of power and overheating. For proper size cords see chart below.
• CHECK FOR DAMAGED PARTS. Before further use of the mower, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect their operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated elsewhere in this manual.
• REPAIRS AND SERVICE. Repairs, maintenance and any adjustments not specified in this manual should be performed by Black+Decker authorized service centers or other qualified service organizations, always
4
