TROUBLESHOOTING GUIDE
Common Power Output Problems – 115 Volt AC
Possible Cause
Red battery status LED indicator is flashing and there is no output
Recommendations
Unit is in charging mode. For optimum results, allow unit to complete charging cycle before using.
Battery Status LED indicators are all lit, but there is no output
Charging is complete, disconnect charging adapter from unit and wall receptacle. Wait 5 minutes before using inverter.
Inverter sudden shutdown, Inverter Status LED is lit red
and green Battery Status LEDs are lit
Inverter Status LED is lit red
and green Battery Status LEDs are lit, but there is no AC power
LED indicators are off,
unit may not be in the ON position
Unit shuts down after a few minutes, internal battery voltage is low
Overload condition, reduce load to a maximum of 16 watts and attempt a manual reset
Unit shutdown from overload or fault condition, attempt manual reset and reduce load
Hold ON/OFF pushbutton for at least 1 second to turn unit ON
Internal battery pack needs recharging, refer to charging instructions on page 7
Common Power Output Problems – USB Outlet
Possible Cause | Recommendations |
No power from USB port | Hold ON/OFF Pushbutton for at least 1 |
| second to turn unit on. |
Device connected to USB port | Be sure device can be charged through |
is not charging | USB Port and current draw is not larger |
| than 350 mA |
For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK & DECKER help line at
10
