631798-01, CS1000L Cir Saw 12/16/05 1:14 PM Page 10
TO USE LASER LINE ON SAW
•Mark the line that you intend to cut on the workpiece.
•Adjust the depth and angle of cut as required.
•Switch the laser to the “ON” position and project the laser beam as shown in figure 14.
14 |
•Plug in the saw and squeeze the trigger.
•Allow the blade to reach maximum speed and place the saw on the workpiece. Align the laser line with the mark on the workpiece and slowly push the saw forward keeping the laser line on the mark.
•Upon completion of the cut, release the trigger and allow the saw blade to come to a complete stop before switching off the laser.
TO USE LASER OFF SAW
The laser can be removed from the saw and used for a variety of different applications.
To use the laser off the saw, fold down the front leg as shown in figure 15.
The laser can also be used in conjunction with the protractor in three different ways:
(1)360 degrees - To project the laser line any direction in a complete circle, 1st retract the front leg and then insert the two back legs into the groove of the protractor as shown in figure 16.
16
(2)Fixed Position - To use the laser in the fixed position, place the rear legs in the holes on the protractor. Refer to figure 17 for the angles created when using the laser in these holes.
(3)Protractor on Edge of Workpiece - To use the laser on the edge of your workpiece, rotate the legs of the protractor so that they are straight up and down as shown in figure18. Place the protractor against the edge of the workpiece and center the large hole of the protractor over the intended line of cut.
15
17
18 |
BBAA
EE DD
CC 
CC
DD EE BB AA
AAto AA = 0° Right
BBto BB = 0° Left
CCto CC = 90°
DDto DD = 45° Left
EEto EE = 45° Right
10
