Operating Instructions

WARNING: To reduce the risk of serious personal injury, read, understand and

follow all safety warnings and instructions prior to using tool.

WARNING: It is important to support the work properly and to hold the drill firmly to prevent loss of control which could cause personal injury. If you have any questions on how to properly operate tool, call: 1-800-544-6986.

WARNING: Do not attempt to tighten drill bits (or any other accessory) by gripping the front part of the chuck and turning the tool on. Damage to the chuck and personal injury may occur when changing accessories.

WARNING: To reduce the risk of injury, always unplug drill from power supply before making any adjustments or changing accessories.

WARNING: To reduce the risk of injury, let the tool work at its own pace. Do not overload.

Selecting the direction of rotation

For drilling and for tightening screws, use forward (clockwise) rotation. For loosening screws or removing a jammed drill bit, use reverse (counterclockwise) rotation.

WARNING: Never change the direction of rotation while the motor is running.

Models DR260, DR340

• To select forward rotation, push the forward/reverse slider (3) to the right (when viewed from the chuck end).

• To select reverse rotation, push the forward/reverse slider (3) to the left (when viewed from the chuck end).

Model DR560

• To select forward rotation, push the forward/reverse slider (3) to the left (when viewed from the chuck end).

• To select reverse rotation, push the forward/reverse slider (3) to the right (when viewed from the chuck end).

Switching on and off

• To switch the tool on, press the variable speed switch (1). The tool speed depends on how far you press the switch.

• For continuous operation, press the lock-on button (2) and release the variable speed switch. This option is available only at full speed.

• To switch the tool off, release the variable speed switch. To switch the tool off when in continuous operation, press the variable speed switch once more and release it.

WARNING: The drill should only be locked ON when it is held stationary in a drill press stand or other means; NOT BY HAND! Never unplug the tool with the locking feature engaged. To do so will cause the tool to start immediately the next time it is plugged in.

Built-in level (DR260, DR340)

 

 

 

G

Your drill is equipped with a bubble level that assists you in drilling

 

level holes.

 

For horizontal drilling, tilt the drill up or down as required so the bubble floats in the center of the parallel lines drawn on the glass.

When the bubble (6) is centered between the lines, as shown

in

figure G, the drill is level.

 

To assure accuracy, first place a level on your workpiece and

6

 

position it so that it is level. Then, when the drill reads level, the

 

two will be aligned. (Any bubble level can only indicate level

 

 

relative to the earth.)

 

 

NOTE: The level is filled with mineral oil that may cause

 

 

minor skin or eye irritation when contacted. If the level breaks

If

 

and this fluid gets on your skin, rinse thoroughly with water.

 

any liquid gets in your eyes, rinse thoroughly with water and call

a

 

physician immediately.

 

8

Page 8
Image 8
Black & Decker DR260, DR560, DR340B Operating Instructions, Selecting the direction of rotation, Switching on and off