Assembling of base and stand

1.Rotate the screw in the anti-clockwise direction and remove it from the support tube.

2.Place the support tube onto the base and then tighten the screw in the clockwise direction.

3.To assemble the main unit, release a few inches of the adjustable tube by operating the screw.

ENGLISH

2.Mount the fan blade onto the motor shaft. Fasten the blade cap by rotating it in the anti-clockwise direction until the blade is fixed firmly into place.

3.Open the securing clip at the bottom of the front guard and loosen the clip screw. Position the top clip on the uppermost part of the rear guard. Push the top clip down and press rim of the front guard onto the rear guard. Close the bottom clip and tighten the screw.

Motor

Rear guard

Fan blade

Front guard

4.Fit the main unit on the adjustable tube and secure it in place by tightening the screw.

Assembly of the fan

1.To install the rear guard, remove the blade cap and guard nut from the motor

shaft. Then attach the rear

guard by positioning it on Finish the location pins on the

main unit. Secure the guard on to the motor body by fastening the guard nut, turning it clockwise until the guard is locked into position.

Operations

Your Fan has three speed control to keep the desired air flow through your room

0 - Off

1 - Low

2

- Medium

 

 

 

 

 

 

 

0

3

- High

3

1

2

 

 

 

 

 

You can press the oscillating control knob down to make the fan oscillate to position the fan in specific direction pull the knob up.

5

Page 5
Image 5
Black & Decker FS1600R manual Assembling of base and stand, Assembly of the fan, Operations