(Original instructions) | ENGLISH |
Troubleshooting
If your appliance seems not to operate properly, follow the instructions below. If this does not solve the problem, please contact your local Black & Decker repair agent.
Problem | Step | Possible solutions | |
|
|
| |
The steam mop is | 1 | Check the unit is plugged in at the wall | |
not turning on. |
| socket. | |
| 2 | Check the unit is switched on using the on/ | |
|
| off switch (1). | |
|
|
| |
| 3 | Check the fuse in the plug. | |
|
|
| |
The steam mop is | 4 | The steam mop will only produce steam | |
not producing |
| once the handle is pulled back from the | |
steam. |
| upright position. | |
| 5 | Check that the water tank (3) is full and | |
|
| correctly fitted. | |
|
| NOTE: When first filled or after running dry it | |
|
| can take up to 45 seconds for steam to be | |
|
| produced. | |
|
|
| |
| 6 | Check that the Steam head (5) is firmly | |
|
| docked into the steam mop body (12). | |
|
|
| |
| 7 | Check steps 1, then 2 then 3. | |
|
|
| |
The steam mop | 8 | Check steps 4, then 5, then 6 and then 3. | |
stops producing |
|
| |
steam during use. |
|
| |
|
|
| |
The steam mop is | 9 | The steam mop has 3 settings. Turn the | |
producing too |
| autoselect dial (2) to increase the amount of | |
much steam during |
| steam being produced. | |
use. |
|
| |
|
|
| |
The steam mop is | 10 | Check step 5. | |
producing too little |
|
| |
11 | The steam mop has 3 settings. Turn the | ||
steam during use. | |||
| autoselect dial (2) to reduce the amount of | ||
|
| ||
|
| steam being produced. | |
|
|
| |
Steam is escaping | 12 | Refer to the assembly chapter of the manual | |
from unexpected |
| for correct fitting instructions of all parts and | |
areas of the unit. |
| accessories. | |
|
|
| |
Where can I get | 13 | www.blackanddecker.co.uk/steammop | |
further information |
| www.blackanddecker.ie/steammop | |
/ accessories for |
|
| |
my steam mop. |
|
| |
|
|
|
7